Prototype Construction

I started with a Euro follower from a Bulgy black mag, which has the thickest of all the lips over which the follower is installed.  Peened it flat and used it as a template to scribe onto the sheet metal.  I used 26-gauge sheet metal for the prototype.

Creating the Template.

Looks kinda like the shadow of the Battlestar Galactica, doesn't it? ;)

First operation - Cut the blank from the sheet metal stock, place on the stamping jig.

Second operation - Create the dimples

Third operation - First bend for the side and rear lip

Fourth operation - Second bend for the side lips

Fifth operation - Removal of the follower

Sixth operation (not shown) - file the center hole square

Ready to test-fit!

Fit on mag.  Note - need to square off the center hole for the follower lug to properly lock up the follower.